Page 1 of 1
Repetier-Host setting on ABS print
Posted: Thu Mar 19, 2015 7:23 pm
by animetown9
Hi
Does anyone here have a good setting for Repetier-Host ABS printing with
Acrylic Geeetech I3 pro and Sanguinololu 1.3a.
Re: Repetier-Host setting on ABS print
Posted: Fri Mar 20, 2015 10:01 am
by zhangxueyou
Please tell me the filament diameter and nozzle diameter.
Re: Repetier-Host setting on ABS print
Posted: Fri Mar 20, 2015 3:22 pm
by animetown9
Hi
Filament 1.75 , nozzle 0.3mm
ABS filament.
Re: Repetier-Host setting on ABS print
Posted: Fri Mar 20, 2015 4:11 pm
by zhangxueyou
Re: Repetier-Host setting on ABS print
Posted: Wed Nov 11, 2015 11:46 am
by johnz
How about setting for 1.75 and 0.4 ABS?? Thanks
Re: Repetier-Host setting on ABS print
Posted: Wed Nov 11, 2015 5:56 pm
by Mark
you can use the settings above too, just need to change the diameter of the nozlle to 0.4mm.
- QQ截图20151111175429.jpg (153.12 KiB) Viewed 13745 times
- QQ截图20151111175551.jpg (281.52 KiB) Viewed 13745 times
Also you can refer to the link here to use the repetier host:
http://www.repetier.com/#documantation
Re: Repetier-Host setting on ABS print
Posted: Tue Aug 07, 2018 11:19 am
by Derekchong
I followed these setting but the print out is horrible. Any good advise?