G2s - Firmware not writing
Posted: Mon Feb 14, 2022 7:08 am
So I was gifted a Gs2 that needed a little work to get up and running, and as part of that I tried to upgrade it to Marlin. I used the SD software from this forum to remove the existong firmware, all went well. However, when I try to flash new firmware (again from this forum) the printer doesn't change after I turn it on.
As I said, it's a single extruder G2s using a GTMS2 pro mainboard.
I used the instructions here: https://www.geeetech.com/forum/viewtopi ... 20&t=60425
And the firmware from Number 11 on this page: https://www.geeetech.com/forum/viewtopi ... 20&t=17046
Any help is appreciated
As I said, it's a single extruder G2s using a GTMS2 pro mainboard.
I used the instructions here: https://www.geeetech.com/forum/viewtopi ... 20&t=60425
And the firmware from Number 11 on this page: https://www.geeetech.com/forum/viewtopi ... 20&t=17046
Any help is appreciated