Edit firmware A20M
Posted: Sat Dec 18, 2021 7:26 am
I've upgraded my A20M with an 3D-touch probe.
But I would like to adjust the grid a bit.
I need to make some changes for this in the firmware. But I completely don't have a clue on how to get to the "Configuration.h".
Alternatively I was thinking making the adjustments to firmware file and upload it again. But this seems to be an *.HEX file.
Annyone anny ideas on how to achief this?
Btw, I would like to increase the upper 10mm to about 25mm. So I will have a bit more space at the adge to place clamps without having risk of being hit by the nozzle or probe.
But I would like to adjust the grid a bit.
I need to make some changes for this in the firmware. But I completely don't have a clue on how to get to the "Configuration.h".
Alternatively I was thinking making the adjustments to firmware file and upload it again. But this seems to be an *.HEX file.
Annyone anny ideas on how to achief this?
Btw, I would like to increase the upper 10mm to about 25mm. So I will have a bit more space at the adge to place clamps without having risk of being hit by the nozzle or probe.