Need latest i3 Pro W firmware (1.0.05) source code

[fb9]

Hi,
I need the source code for the firmware (Marlin version 1.0.05) of the Geeetech i3 Pro W.
I tried searching in the topic dedicated to firmwares on the forum, but the latest version I found was the 1.0.2, that is quite old, and that topic is locked by now.
I also looked in the Pro W page of the main Geeetech site (https://www.geeetech.com/download.html?download_id=36), but there is only the binary HEX version of the firmware v1.0.05, no source code.
Could someone provide the source code of this version (1.0.05)? I made changes to physical axes dimensions and need to change Configuration.h and recompile.
Thank you

[William]

Hello, the forum uploaded is the latest version, you can modify it on the basis of version 1.0.02, version 1.0.05 is the same as before.

[LoBoHEAT]

Hi, 1.0.5 it's very very old, at the I3 Pro B forum you have the last marlin for I3 Pro B/W (2.0.6).

Best regards.

[fb9]

Hello, the forum uploaded is the latest version, you can modify it on the basis of version 1.0.02, version 1.0.05 is the same as before.

Well, I tought there was some bugfix in 1.0.5 that is not present in 1.0.2, but to be honest I just started tinkering with the printer and I'm not very familiar with firmware versions.
Thanks.

[fb9]

Hi, 1.0.5 it's very very old, at the I3 Pro B forum you have the last marlin for I3 Pro B/W (2.0.6).

Best regards.

Are the parameters of Configuration.h the same for pro B and pro W? I just need to change one parameter, X axis length, and it would be great not to have to change other parameters that I don't know

[LoBoHEAT]

Hi, 1.0.5 it's very very old, at the I3 Pro B forum you have the last marlin for I3 Pro B/W (2.0.6).

Best regards.

Are the parameters of Configuration.h the same for pro B and pro W? I just need to change one parameter, X axis length, and it would be great not to have to change other parameters that I don't know

Are the same printer, W is wood frame B is acrylic frame.

Best regards