Geeetech i3 Pro A 3 in 1 control box GT2650 Rev A+ 3DTouch
Posted: Tue Mar 19, 2019 11:36 pm
Hi, I have a Geeetech i3 Pro A 3 in 1 control box GT2650 Rev A+ and I have two 3DTouch and one BLTouch from my other printers and all working on thoes.
I have tried several ways to get the 3D & BL Touchs' to work on this i3 Pro A but I seem to fail all the time.
I see many of the Geeetech printers now have firmware precompiled, but I cannot find one for this printer.
I have tried all other i3Pro's and all instructions from the forum an d wiki's but I still have been unable to get it to work.
Does anyone have a working Geeetech i3 Pro A with the 3 in 1 control box with the 3D/BLTouch working or know where I can get the working Marlin correct firmware for this printer please?
I have the wires for the 3D Touch wired directly to the board pins and not through the intermediate boards
I have tried several ways to get the 3D & BL Touchs' to work on this i3 Pro A but I seem to fail all the time.
I see many of the Geeetech printers now have firmware precompiled, but I cannot find one for this printer.
I have tried all other i3Pro's and all instructions from the forum an d wiki's but I still have been unable to get it to work.
Does anyone have a working Geeetech i3 Pro A with the 3 in 1 control box with the 3D/BLTouch working or know where I can get the working Marlin correct firmware for this printer please?
I have the wires for the 3D Touch wired directly to the board pins and not through the intermediate boards