Weird A10M Firmware Upload Problem
Posted: Thu Feb 21, 2019 10:56 pm
Hi.
I'v recevied my A10m some days ago. I'v readed all manual, and i still got stuck on firmware update.
First of all. My firmware says the printer is a ONE extruder, no dual, so I can't load-unload filament but on extruder 1 via firmware commands (move axis-extruder) But, the printer says is a A10M and with cura it prints with both of them. Marlin 1.1.8
Installed drivers "CH341SER", and printer connects fine with USB. I can move axis when connected to it.
File to upload: A10M_G04_V1.1.8_01.hex from Geeetech
First try: EasyPrint -> there's no A10M model on easyprint. If mark A10, the software advises me there's a different model attached. Anyway tried to upload firmware - No archive found (should I put the Exe File on SD CARD?)
Second Try- Xloader v1.0.. -> set to COM5 Baud 250000. FAiled to upload.
Third Try - CURA 3.4.1 (and 15.04.06)- Printer settings, but when say to upload, the proress bar is freezed. Not even starts.
The board in the printer is a GT2560V3
I'v recevied my A10m some days ago. I'v readed all manual, and i still got stuck on firmware update.
First of all. My firmware says the printer is a ONE extruder, no dual, so I can't load-unload filament but on extruder 1 via firmware commands (move axis-extruder) But, the printer says is a A10M and with cura it prints with both of them. Marlin 1.1.8
Installed drivers "CH341SER", and printer connects fine with USB. I can move axis when connected to it.
File to upload: A10M_G04_V1.1.8_01.hex from Geeetech
First try: EasyPrint -> there's no A10M model on easyprint. If mark A10, the software advises me there's a different model attached. Anyway tried to upload firmware - No archive found (should I put the Exe File on SD CARD?)
Second Try- Xloader v1.0.. -> set to COM5 Baud 250000. FAiled to upload.
Third Try - CURA 3.4.1 (and 15.04.06)- Printer settings, but when say to upload, the proress bar is freezed. Not even starts.
The board in the printer is a GT2560V3