Firmware 1.1.8 for i3 Pro C GT2560 A+ BLTouch dual Extruder
Posted: Sat Dec 08, 2018 2:57 am
Adapted for a Pro C, on the basis of the Pro B version available in this section thanks to wwysocki.
The good news is the menu which now include the E1 and E2 parameters (Control / Motion) and ... ability to tune / feed them each with their own command / parameters.
Requires Arduino 1.8.x to be compiled/uploaded
Hope it helps
Link :https://drive.google.com/drive/folders/ ... sp=sharing
Thierry
The good news is the menu which now include the E1 and E2 parameters (Control / Motion) and ... ability to tune / feed them each with their own command / parameters.
Requires Arduino 1.8.x to be compiled/uploaded
Hope it helps
Link :https://drive.google.com/drive/folders/ ... sp=sharing
Thierry