GT2560 v3 I need burn Bootloader????
Posted: Mon Oct 01, 2018 6:32 pm
Hello, I have an A10M, charge the firmware since the last Arduino IDE version, the machine from lcd responds perfectly, until the autolevel with BLTouch.
The problem is when you communicate with Any Software by usb, be it Cure, Simplify, Repetier, Easy3D ...
It connects the port well and it even makes me G28 and G29 from any of them, but when it finishes doing the G28, I give it the order of a G1 Z10 for example, and it starts to move slowly and forward, not up, let's go it goes crazy
Do I need to load bootloader ????
Is there a specific connection scheme and some guidance to do so on the GT2560 v3 board ?????
Some help would come from pearls!
Thank you.
The problem is when you communicate with Any Software by usb, be it Cure, Simplify, Repetier, Easy3D ...
It connects the port well and it even makes me G28 and G29 from any of them, but when it finishes doing the G28, I give it the order of a G1 Z10 for example, and it starts to move slowly and forward, not up, let's go it goes crazy
Do I need to load bootloader ????
Is there a specific connection scheme and some guidance to do so on the GT2560 v3 board ?????
Some help would come from pearls!
Thank you.