Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

LEAD SCREW steps per mm nothing change

http://geeetech.net/forum/viewtopic.php?f=20&t=60334

Page 1 of 1

LEAD SCREW steps per mm nothing change

Posted: Mon Oct 02, 2017 3:55 am
by panosa
why when i change the steps per mm Z axis and upload the firmware (all done) nothing is changing .I have the same speed as it was before.i have enabled EEPROM also ..Is it anything else i need to do or my board has problem

Re: LEAD SCREW steps per mm nothing change

Posted: Thu Oct 05, 2017 11:33 am
by William
Maybe you should check if the change is worked via LCD panel to cat the Z-axis steps/mm.
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/