Page 1 of 1
Firmware for Geeetech Rostock Mini Pro G2S pro
Posted: Wed Jun 07, 2017 9:33 pm
by ChrisP28
Has anybody got a copy of the firmware for this printer? I ave assembled it from a kit but I can't get the firmware for the board to load. the firmware copy I've downloaded shows errors when I try to compile it as shown in the build instructions. Need help big time. I have contacted Geeeteck's support line directly but no response.
Re: Firmware for Geeetech Rostock Mini Pro G2S pro
Posted: Thu Jun 08, 2017 8:38 am
by William
Hi,I wanna know which version of Arduino are you using?The recommend selection is version 1.0.1.Try to redownload the related firmware in this post:
http://www.geeetech.com/forum/viewtopic ... 20&t=17046.
If it still cannot work,I suggest you to upgrade the firmware with EasyPrint 3D.
Here is the download link:
http://www.geeetech.net/firmware/EasyPrint.msi.
And here is the instructional video you can refer to
:
https://www.youtube.com/watch?v=U3ua4vM ... pqufTgHOgE.
Please let me know the result after upgrading.
Re: Firmware for Geeetech Rostock Mini Pro G2S pro
Posted: Thu Jun 08, 2017 1:32 pm
by ChrisP28
Hi William
I work away from home but I'll follow your instructions at the weekend and let you know in a couple of days.
regards.
Re: Firmware for Geeetech Rostock Mini Pro G2S pro
Posted: Thu Jun 08, 2017 1:49 pm
by William
Hope it can help.
