Page 1 of 1
Printer Origin ?
Posted: Mon May 08, 2017 9:47 pm
by FishMan
Hopefully, a quick one....
Where is 0,0,0 ?
If it's on the bed front left, then how do I set up Marlin firmware to "know" that my micro-switch end-stops are not at 0,0,0 ?
Thanks,
Re: Printer Origin ?
Posted: Tue May 09, 2017 3:25 pm
by William
What kind of machine do you have?
Re: Printer Origin ?
Posted: Tue May 09, 2017 3:54 pm
by FishMan
Hi,
As in sig...
GeeeTech i3 Pro C. GT2560 RevA+. 3DTouch.
Cheers,
Paul
Re: Printer Origin ?
Posted: Fri May 12, 2017 10:55 am
by William
FishMan wrote:Hopefully, a quick one....
Where is 0,0,0 ?
If it's on the bed front left, then how do I set up Marlin firmware to "know" that my micro-switch end-stops are not at 0,0,0 ?
Thanks,
The home position is in the front left of the glass.To make your extruder home right,you can increase the length of the Endstop trigger.Here is the pictures.
- QQ截图20170512105049.png (28.81 KiB) Viewed 6514 times
- QQ截图20170512105432.png (47.61 KiB) Viewed 6514 times