Geeetech

Hi,

Would like some help. Noticed that if I disconnect power from the Geeetech Prusa i3 Pro C, then turn it back on, the E-steps reset from whatever value I had configured back to 78.74 - which I think is what it initially was configured with. This E-step resetting caused a print to have very off measurments...

Is the printer not supposed to remember my configurations set from the on board display? Can it be configured to remain what I need it to be? Would editing the fomware from the arduino program help? If yes, where would I find the correct line for the E-steps?

Thanks for any help.

Hi,after every time you change the parameters, you will need to save the Settings.You can operate the LCD to do so, the main menu > control > store the memory.