3d Printer 3 in 1 insertion

[Dima]

Whether there is a step-by-step instruction on an insertion the 3D printer a 3 in 1 sprout with a payment of management of control board GTM32 set. Arduino which I downloaded don't support such payment what to do? Also prompt where it is possible to download an insertion for this printer. Thanks

[William]

Hi,here is the instruction of 301:http://www.geeetech.com/wiki/images/5/5 ... uction.pdf.

[Dima]

I have GTM32 pro payment +
6 A4988, tell where to download an insertion on the printer 3 in 1 with such payment. and that an insertion which I have found didn't manage to be established. and now the printer doesn't work.

[Dima]

here what occurs at a payment insertion what to do?

[William]

Hi,it seems to have some problems in the firmware,and you can download the lastest and re-upload it according to the post in the following link:viewtopic.php?f=20&t=18167.Please let me know the latest situation,Good luck.

[Dima]

I just tried to go too far the printer according to this instruction

[William]

Hi,According to the pictures show, it is because the mainboard is not in burning mode, please take a closer look at the post,especially point 4 and behind. Before getting into burning mode you need to let the mainboard reset .You can click and hold "C" button on the keyboard to reset the board.It also will be okay if you press the reset button on the board directly.

[Dima]

At me everything has turned out, thanks for the help

[William]

Glad to help you