Home problems with Pro C
Posted: Mon Mar 06, 2017 1:39 am
After eliminating the inverted X-axis problem, now is the X axis Z, do not stop at the end positions.
The motors do not stop, continue to run and jump belts. I first tried to give the home position from the LCD, but nothing. Then from Repetier Host and still nothing. Then I decided to remove the X-axis motor, keep the truck resting on the switch and after a while it stopped. I reassembled and tried it and it worked.
But with the Z axis I'havvent the same luck and after the emergency STOP from Repetier, also the Y-axis does not work again.
But how much confusion you did with that mainboard!!!
The motors do not stop, continue to run and jump belts. I first tried to give the home position from the LCD, but nothing. Then from Repetier Host and still nothing. Then I decided to remove the X-axis motor, keep the truck resting on the switch and after a while it stopped. I reassembled and tried it and it worked.
But with the Z axis I'havvent the same luck and after the emergency STOP from Repetier, also the Y-axis does not work again.
But how much confusion you did with that mainboard!!!
