Geeetech

hi I have bought the 3d touch and the gt2560A+ board for my i3 pro everything has been installed following the manual but now my y axis is not working correctly it starts its auto level process and then just jams the bed all the way forward and then all the way back and I have to emergency stop my printer how can I fix this.
it was working fine with this board to make the mount for the 3d touch but since I downloaded the firmware from geeetech and then changed what was need from the manual it dosnt work.

thank in advance for your help

hi, there's something you need to know before using 3D Touch.
viewtopic.php?f=27&t=18371

thanks William
but my probe points still not right it keeps going off the board and I have to e stop where can I change this
or can you post copy of completed firmware for i3 pro b with 2560 rev a+
thanks

What kind of leveling are you using (linear, 3 point, bilinear) and what are your probing points? It may be trying to probe an area it can't reach.

I know the link where you can download the firmware of all versions.
viewtopic.php?f=20&t=17046