Prusa i3x auto bed leveling problems

[Tropax]

Hi i have tryed to enable auto bed levelig. But it only checks one spot on the bed?!?!
I removed the // to enable auto bed leveling ,like showned on youtube and set my dimensions.
But still it only checks one spot (almost center)

I want it to select grid at least the 4 corners.
Is there somthing im missing or a bad firmware? I got it at geeetech. Can any one send me a modified one that they used so i can see or test?

[William]

Hi i have tryed to enable auto bed levelig. But it only checks one spot on the bed?!?!
I removed the // to enable auto bed leveling ,like showned on youtube and set my dimensions.
But still it only checks one spot (almost center)

I want it to select grid at least the 4 corners.
Is there somthing im missing or a bad firmware? I got it at geeetech. Can any one send me a modified one that they used so i can see or test?

Hi,
Did you get a 3DTouch?Have you checked the instructions?
http://www.geeetech.com/forum/viewtopic ... 27&t=18263

[Tropax]

no im useing a inductive sensor. it Works but only chekes one spot? ca in the middel of the table