Page 1 of 1

M201 "Stop Print" Cooling down

Posted: Mon Aug 22, 2016 9:40 pm
by Wrench900
When running a print from the SD card on my M201, if I decide the print didn't start or notice an issue with the print, I scroll to "Stop Print." The print finishes the command line it is on, stops printing and moves to x axis home. What I can't figure out is why the printer doesn't change the settings to cool down. The only way I have found to do this was turn the power off and on again.
I'm I missing something?

Re: M201 "Stop Print" Cooling down

Posted: Tue Aug 23, 2016 10:32 am
by William
Wrench900 wrote:When running a print from the SD card on my M201, if I decide the print didn't start or notice an issue with the print, I scroll to "Stop Print." The print finishes the command line it is on, stops printing and moves to x axis home. What I can't figure out is why the printer doesn't change the settings to cool down. The only way I have found to do this was turn the power off and on again.
I'm I missing something?
No,you didn't miss anything,that is the default setting in the firmware.It saves the time for heating when you wanna restart it or notice an issue on the print,isn't it?