Page 1 of 1
M201 Set Thermistor Type
Posted: Sat Jul 16, 2016 3:54 am
by cerealkillers
I'm about to fit an E3D Lite6 to my M201 and therefore to the GTM32 board. Is it possible to set the thermistor type? The instructions on E3Ds page are for the various open firmware types out there:
http://wiki.e3d-online.com/wiki/E3D-Lit ... Easy.21.29
I'd rather not replace the control board since I'd like to be able to swap back to the 2-into-1 heatblock when required.
Thank you.
Re: M201 Set Thermistor Type
Posted: Sat Jul 16, 2016 11:27 am
by William
cerealkillers wrote:I'm about to fit an E3D Lite6 to my M201 and therefore to the GTM32 board. Is it possible to set the thermistor type? The instructions on E3Ds page are for the various open firmware types out there:
http://wiki.e3d-online.com/wiki/E3D-Lit ... Easy.21.29
I'd rather not replace the control board since I'd like to be able to swap back to the 2-into-1 heatblock when required.
Thank you.
Hi,
I'm afraid you can't make some modifications in firmware on GTM32 board...
Re: M201 Set Thermistor Type
Posted: Wed Jul 20, 2016 12:34 am
by The1Fl4sher
@ William Kwok : Are you sure you can not change the firmware.
Re: M201 Set Thermistor Type
Posted: Wed Jul 20, 2016 11:09 am
by William
The1Fl4sher wrote:@ William Kwok : Are you sure you can not change the firmware.
Yes,cuz the GTM32 board is not open source...