Problem setting up auto leveling
Posted: Mon Apr 18, 2016 3:36 pm
Hi
So now my problem is setting up auto levelling.
In Marlin configuration h I have changed the z level offset for the probe and to what I think is correct and changed Z_raise after homing to 50. I have added G29 to the special codes of slic3r and uploaded the firmware again. When I run G29 the machine probes the table nicely but does not move up to Z50 when finished. And when I start a print the hot end is about 2mm above the build table. It is as if the firmware has not changed.
Grateful for any advice
Aaron
So now my problem is setting up auto levelling.
In Marlin configuration h I have changed the z level offset for the probe and to what I think is correct and changed Z_raise after homing to 50. I have added G29 to the special codes of slic3r and uploaded the firmware again. When I run G29 the machine probes the table nicely but does not move up to Z50 when finished. And when I start a print the hot end is about 2mm above the build table. It is as if the firmware has not changed.
Grateful for any advice
Aaron