Page 1 of 1
EEPROM settings - clear?
Posted: Thu Apr 14, 2016 4:05 pm
by robvoi
I use the GT2560.
How do I make sure I use the settings from the firmware, not some settings stored in the EEPROM?
(I am preparing for my 1st print - so sorry if the queston is a bit stupid
)
Re: EEPROM settings - clear?
Posted: Thu Apr 14, 2016 5:57 pm
by Mark
If you don't know whether you changed any settings or not, then I guess you need to restore to the default settings, and then try it....
Re: EEPROM settings - clear?
Posted: Thu Apr 14, 2016 6:01 pm
by robvoi
How do I restore to the default?
Is this the "Load Fail Save config" point (I think it was nemed like this)?
Re: EEPROM settings - clear?
Posted: Thu Apr 14, 2016 7:53 pm
by Mark
yeah I remember this is it. Or you can just reinstall the firmware.
Re: EEPROM settings - clear?
Posted: Wed Apr 20, 2016 3:43 pm
by stado65
You can try the M502 Gcode : Revert to the default "factory settings."