Geeetech

Hi all!
I have big problem with Prusa i3 X.
I set all my software up like in the manual. But when i start printing the printed move at: Z goes at maybe 50% height, the X and Y goes in the other side of bed, and start to print in middle air in totally wrong position.
I set Home point right at (0,0,0) but when i try to to put the printer head in Park position (presetted at X 100, Y 100, Z 0 by repetierhost), it run for something like 180 at X and also at Y. But if i just use arrows (in repetierhost) or move axis direcly from controller, the print head move correctly, without error in dimension moves

I'sure it's a Firmware problem, but i dont know how to fix it.

(The firmware is the one i donwloaded from official post released few days ago)

Could your printer homing well? I mean when homing, do all the motors move toward the endstop?
Also how about the distance between the nozzle and bed after homing? you need to set it to about the thickness of a normal paper.
Maybe post a video here to see what happened.

Than you Mark!
I solved just flashing an other time the EEPROMS. I don't know why it was setted at center of the plate