Page 1 of 2
firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 2:16 pm
by rogue88
Hello, friends.
I need a firmware for Geeetech Prusa I3 M201, GTM32.
Thank You
P.P.
kto@progress-sz.com
Re: firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 3:08 pm
by Mark
Re: firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 3:33 pm
by rogue88
Thank You, the firmware is updatet.
But!
I have installed Repetier Host 0.9 and 1.6 and a couple of drivers. The printer can not be seen.
Other problem that I have is with positioning x and y.
Please help
Re: firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 4:47 pm
by Mark
have you tried the FTDI driver? is the same as the GT2560.
you can download it here:
http://www.geeetech.com/wiki/index.php/ ... he_drivers
Re: firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 4:58 pm
by rogue88
Yes, I am with this driver. When I connect usb cable of the printer, It connects to COM6.
If I try in Repetier Host another Com, It gives a mistake.
When I connect Com6, it says nothing, but I can not move , nothing. It looks like as not connected.
What can I do?
Re: firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 5:09 pm
by Mark
the baud rate is 115200 and the receive cache size is 63, did you set it correct?
Re: firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 5:29 pm
by rogue88
Yes, It shows only, that 6-7-14 commands waiting.
This is down in the middle.
Any advice?
Re: firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 5:53 pm
by Mark
does your LCD working? how about other baud rate?
Re: firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 6:20 pm
by rogue88
Yes, LCD works. I have tried all the rate untill 230400. Nothing happens.
Re: firmware for Geeetech Prusa I3 M201
Posted: Tue Dec 08, 2015 7:25 pm
by rogue88
So I have succeed to start the printer with Repetier Host 1.6.
But I still have a problem with Xo and Yo.
The second problem ist with the extruder heater. He wouldn't start? Why?