Geeetech

Hello,
Autoleveling configure:
My coordinate of the probe on the manual control panel is (24, 13,1.5)
My 3D Printer is G2S with 2 hotend.
In Configuration-h I modifiy: X_PROBE_OFFSET_FROM_EXTRUDER -24 and Y -11 and Z -1.5 Is it correct?
Then I compile and I have error below.
More, with values that do not make mistakes, the printer is completely crazy. Could someone help me?
Thank's in advance.

did you change any other settings? you can try to download the original firmware and compile it, see if it has the same problem.

I think I had the same problem when I made x > 19

just leave the X =-19, it won't affect the auto leveling.