impossible to compile after autolevel configuration

Post Reply
lacurie
Posts: 2
Joined: Sun Dec 06, 2015 12:08 am

impossible to compile after autolevel configuration

Post by lacurie » Sun Dec 06, 2015 1:49 am

Hello,
Autoleveling configure:
My coordinate of the probe on the manual control panel is (24, 13,1.5)
My 3D Printer is G2S with 2 hotend.
In Configuration-h I modifiy: X_PROBE_OFFSET_FROM_EXTRUDER -24 and Y -11 and Z -1.5 Is it correct?
Then I compile and I have error below.
More, with values that do not make mistakes, the printer is completely crazy. Could someone help me?
Thank's in advance.
Attachments
MESSAGE ERREUR COMPIL ARDUINO.jpg
MESSAGE ERREUR COMPIL ARDUINO.jpg (157.92 KiB) Viewed 6105 times
Top
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: impossible to compile after autolevel configuration

Post by Mark » Tue Dec 08, 2015 2:12 pm

did you change any other settings? you can try to download the original firmware and compile it, see if it has the same problem.
Top
smithti8
Posts: 12
Joined: Sat Jun 13, 2015 3:16 am

Re: impossible to compile after autolevel configuration

Post by smithti8 » Thu Jan 14, 2016 10:43 am

I think I had the same problem when I made x > 19
Top
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: impossible to compile after autolevel configuration

Post by Mark » Thu Jan 14, 2016 5:58 pm

just leave the X =-19, it won't affect the auto leveling.
Top
Post Reply

Return to “Firmware”