Prusa I3 not working.
Posted: Fri Oct 09, 2015 2:05 am
I have an issue with my prusa I3, iduino/ramps 1.4
It will not be recognized by any computer when the ramps is installed. This has been tested with 2 ramps, 2 iduinos, and 4 computers. I am out of ideas. The iduino is recognized with the ramps disconnected. Have rewired following instructions over and over.
It will not be recognized by any computer when the ramps is installed. This has been tested with 2 ramps, 2 iduinos, and 4 computers. I am out of ideas. The iduino is recognized with the ramps disconnected. Have rewired following instructions over and over.