Page 1 of 2
firmware for Sangoinololu 1.3a
Posted: Mon Jul 20, 2015 6:03 pm
by BQSOLDest
Good afternoon!
Tell me where you can download the firmware for Sangoinololu 1.3a?
Re: firmware for Sangoinololu 1.3a
Posted: Tue Jul 21, 2015 3:21 pm
by Sherry
BQSOLDest wrote:Good afternoon!
Tell me where you can download the firmware for Sangoinololu 1.3a?
could you tell me your printer type?
Re: firmware for Sangoinololu 1.3a
Posted: Tue Jul 21, 2015 3:38 pm
by BQSOLDest
geeetech I3B acrilic
Re: firmware for Sangoinololu 1.3a
Posted: Thu Aug 13, 2015 8:04 am
by amigone
I all so need the firmware for sangoinololu 1.3a prusa i3b
Re: firmware for Sangoinololu 1.3a
Posted: Thu Aug 13, 2015 9:14 am
by Mark
Download it here .
Re: firmware for Sangoinololu 1.3a
Posted: Fri Aug 14, 2015 1:07 pm
by MannyJayBustos
I would like to use grid mode in marlin but the firmware for my printer is old . Could you send me over the latest marlin firmware for my printer?
Geeetech I3b clear with Sangoinololu .
mannyjaybustos@gmail.com
Thanks
Manny
Re: firmware for Sangoinololu 1.3a
Posted: Sun Aug 16, 2015 4:46 am
by MannyJayBustos
Thanks for the files. However the Marlin firmware is 1.0.0. Is there a way to get me firmware with Marlin 1.0.2 ? Of not ,can you show how to install a Marlin update ? I am not sure how to do it.
Geeetech /I3b /clear / Sangoinolou
Thanks
Manny
Re: firmware for Sangoinololu 1.3a
Posted: Sun Aug 16, 2015 5:07 am
by MannyJayBustos
Sorry I did not put my e mail in my last post
mannyjaybustos@gmail.com
Thanks Manny
Re: firmware for Sangoinololu 1.3a
Posted: Mon Aug 17, 2015 3:27 pm
by Mark
Reburn your firmware as the pic shows.
Re: firmware for Sangoinololu 1.3a
Posted: Tue Aug 18, 2015 8:11 am
by MannyJayBustos
You are not answering my question.. Do you have Firmware that has Marlin 1.0.2. ? The firmware you sent me is Marlin 1.0.0. My printer was to have the latest firmware when I purchased it in April of 2015 . Marlin 1.0.2 Is the current firmware with a release of January 2015.
Manny