Geeetech

Hi

I figured out how to load the firmware, I found the latest on this forum in a recent post, but then I saw that there are some settings for the configuration H that can be changed. As I am fairly new to this I was not sure exactly if I should change these settings.

I am able to communicate with Repetier Host and can manually move the motors.

Can anyone point me in the right direction?

JETNC wrote:Hi

I figured out how to load the firmware, I found the latest on this forum in a recent post, but then I saw that there are some settings for the configuration H that can be changed. As I am fairly new to this I was not sure exactly if I should change these settings.

I am able to communicate with Repetier Host and can manually move the motors.

Can anyone point me in the right direction?

could the printer work now?some modified the firm as the extruder could not work properly.if your printer is OK,Please do not change it.
here is the tutotial for file burning.
http://www.geeetech.com/wiki/index.php/ ... le_Burning

I am traveling out of state this week and won't be able to try this firmware until Saturday.

I did get a print with the firmware I found but perhaps the version that Sherry just sent me is newer.