One-way motors
Posted: Sun Jul 12, 2015 5:24 am
My issue is with the Prusa i3 C with the GT2560 board.
Under manual control, each motor will only move towards the home position. Trying to move away from home gives the message "endstops hit: ". Sending the M119 command indicates that all three min endstops are open and indicates all three max endstops are triggered, but I have no max endstops installed. I ran the M119 command while pressing the min endstops individually and each axis min endstop changed from open to triggered as expected. Is there a setting to tell the program that there are no max endstops installed and allow movement away from the home position or is another solution required?
Thanks
Under manual control, each motor will only move towards the home position. Trying to move away from home gives the message "endstops hit: ". Sending the M119 command indicates that all three min endstops are open and indicates all three max endstops are triggered, but I have no max endstops installed. I ran the M119 command while pressing the min endstops individually and each axis min endstop changed from open to triggered as expected. Is there a setting to tell the program that there are no max endstops installed and allow movement away from the home position or is another solution required?
Thanks