Geeetech

Hello Everybody,

Trying to fix the X Motor direction, I did something bad.
Now my printer is not working because of the bad firmware.

It would be pleasant if anyone could send me the firmware for the next config:
- PRUSA I3 with RAMPS 1.4
- LCD 2004 Controller
- MK2A with 100k NTC Thermistor

Thank you,

Aubin

Do you have email? I can send you the firmware.

I finally find a virgin firmware (marlin) and I made it working for the geeetech prusa i3.
It would be nice from you to send me the firmware to compare and change some details on my firmware.
In fact I have some problems with the temperature regulation when heating the noozle.

My email adress is adef-80@live.fr

Thank you very much for your time.

Aubin

zhangxueyou, I believe I also require the exact same firmware files.
I have an i3 pro with the LCD 2004 controller and a RAMPS 1.4. The vendor we purchased the unit from on Amazon sent us the firmware for the board this unit was apparently supposed to come with, but substituted with this RAMPS 1.4.

my email address is : ssj5jemak @ gmail . com

I too am looking for the firmware for my RAMPS 1.4, could I have a copy of what you are using?
mike3d@hotmail.com

vortex4200 wrote:I too am looking for the firmware for my RAMPS 1.4, could I have a copy of what you are using?
mike3d@hotmail.com

Hi, we'd sent the firmware to your email for twice but failed. So we sent it to your register email, please check.

oh sorry I left something out of my email address lets try that again!
it's mikelang3d@hotmail.com sorry about the mix up.

Mike

Hi there,

Can you please mail me the firmware as well for the Geeetech I3 B, 2560, Ramps 1.4

JacquesW@JTDental.co.za

Jacques wrote:Hi there,

Can you please mail me the firmware as well for the Geeetech I3 B, 2560, Ramps 1.4

JacquesW@JTDental.co.za

Sorry, but the email we sent you was rejected for some unknown reason, could you please leave other email address?

Hi there.

You can try c13pt01@gmail.com