gt9s extruder
Posted: Sat Nov 08, 2014 4:59 pm
Hi friends, i have a gt9s extruder. Anyone know the correct parameters for this lines in marlin???
#define DEFAULT_AXIS_STEPS_PER_UNIT {80,80,2500,450} // default steps per unit for Ultimaker
#define DEFAULT_MAX_FEEDRATE {400, 400, 1, 45} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {1500,1500,100,1500} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for Skeinforge 40+, for older versions raise them a lot.
#define DEFAULT_ACCELERATION 1000 // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 2000 // X,
Only for E.
Thnaks for all.
#define DEFAULT_AXIS_STEPS_PER_UNIT {80,80,2500,450} // default steps per unit for Ultimaker
#define DEFAULT_MAX_FEEDRATE {400, 400, 1, 45} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {1500,1500,100,1500} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for Skeinforge 40+, for older versions raise them a lot.
#define DEFAULT_ACCELERATION 1000 // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 2000 // X,
Only for E.
Thnaks for all.