Burn the bootloader and then upload the firmware.
Then you need to install the drivers for this board,set the baud rate to 115200
How to burn the firmware for GTM32 Pro VB
Re: How to burn the firmware for GTM32 Pro VB
Then you need to install the drivers for this board,set the baud rate to 115200
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: How to burn the firmware for GTM32 Pro VB
Hi.
Do you know what a jumper cap is?
Do you know what a jumper cap is?
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: How to burn the firmware for GTM32 Pro VB
no tengo idea de que es o que ahi que hacer ?
Re: How to burn the firmware for GTM32 Pro VB
ahi que sacar ese cosito negro que sale señalado en la foto ?
Re: How to burn the firmware for GTM32 Pro VB
o ahi que ponerle algo ahi? donde lo consigo ? no se nada de esto !
Re: How to burn the firmware for GTM32 Pro VB
hola he echo los pasos que dice en el foro, y ahora no me anda el lcd y el ventilador del extrusor.
que pudo aver pasado ?
que pudo aver pasado ?
Re: How to burn the firmware for GTM32 Pro VB
It would be extraordinary if these two open source sheets could bolster Marlin 2.x 32bit rendition. I have no clue about coding. However, this would be amazing if Geeetech or clients who can code would make Marlin 2.x to be good with the GTM32 sheets. So much conceivable outcomes and highlights would open up for the clients and furthermore for Marlin. I've seen this issue posted on the Smartto firmware store which as I would see it would have a place here, it's anything but a firmware issue/highlight however increasingly like an equipment issue.