Geeetech 3D Purusa i3 A Pro with separate control box, that lets the BL / 3D Touch actually work?

[frogsuk]

Any New Firmware for the Geeetech 3D Purusa i3 A Pro with separate control box, that lets the BL / 3D Touch actually work?

I know that it has all the settings in the Marlin and have followed all the instructions on the forum, website and other forums.

I have got the probe going up and down and self-test with no problem, but the darn carriage decides not to move. not does it go and do the levelling procedure.

Can the I3 Pro B marlin work? or what do I need to do to make it work?

I have tried two 3DTouch and have the same results.

So any chance or updating the firmware so it is in line as the same format as the new firmware on Geeetech's other models in the download section of the website?

Please dont just send me to the instruction page as i have been through all that many times.
I can send you my Marlin to look at if required