How to burn the firmware for E180

Post Reply
sasoromih.a@gmail.com
Posts: 3
Joined: Tue May 22, 2018 9:07 pm

Re: How to burn the firmware for E180

Post by sasoromih.a@gmail.com » Mon Jun 25, 2018 9:46 pm

Hi, can anyone tell me how to connect ST-link to this board? I can't do anything with STMFlashLoader Demo, no response from printer.
Top
User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:
Contact _kaktus_

Re: How to burn the firmware for E180

Post by _kaktus_ » Tue Jun 26, 2018 1:23 pm

Please, very much.
:mrgreen:
Debug_GTM32_MINI_S.png
debug
Debug_GTM32_MINI_S.png (20.53 KiB) Viewed 24052 times
Just be careful what you do to not block the controller.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Top
Post Reply

Return to “Firmware”