I have an I3 Prusa Aluminium with a sanguino board. After beeing in contact with geeetech support they said I could remove the LCD in order to use the sensor on this board.
Currently I have the sensor wired to the Z-Stop port and at the A0 port where the LCD usually sits. The guide on how to install the software is aimed for GT2650 boards, so I am rather clueless on how I should edit the firmware to suit my board.
Here is the manual on how to install the sensor: https://www.geeetech.com/Documents/3DTo ... ion2.0.zip
Could someone guide me on what code I have to change in order to suit the A0 port on my board?
Much appreciated!
