problem after uploading Marlin 1.1.0-RC8

Post Reply
margond
Posts: 4
Joined: Mon Jan 23, 2017 2:48 pm

problem after uploading Marlin 1.1.0-RC8

Post by margond » Sun Feb 26, 2017 6:15 pm

Hi. After uploading the 1.1.0 RC8 firmware to my prusa i3 Pro B, I have "?" symbols on the LCD on the X,Y,Z position. Anyone knows what mistake I made in the Marlin firmware?
Thanks
Top
margond
Posts: 4
Joined: Mon Jan 23, 2017 2:48 pm

Re: problem after uploading Marlin 1.1.0-RC8

Post by margond » Mon Feb 27, 2017 5:17 pm

HI. Anyone can help me?
Thanks
Top
cosmith
Posts: 52
Joined: Mon Dec 12, 2016 8:58 pm

Re: problem after uploading Marlin 1.1.0-RC8

Post by cosmith » Mon Feb 27, 2017 7:40 pm

Have you tried a G28 home command?
Top
margond
Posts: 4
Joined: Mon Jan 23, 2017 2:48 pm

Re: problem after uploading Marlin 1.1.0-RC8

Post by margond » Mon Feb 27, 2017 9:11 pm

No, I flashed an older version of the firmware, but I wish to know what is wrong in the New version in order to Upgrade my marlin
Top
Post Reply

Return to “Firmware”