Geetech I3 X Problem

Post Reply
CGO
Posts: 3
Joined: Fri Jan 20, 2017 12:23 am

Geetech I3 X Problem

Post by CGO » Fri Jan 20, 2017 12:37 am

Could anybody help me please?
I tried to print after adjusting the hardware and it is not possible due to the z axis goes up then it goes back but it does not touch the bed, as I adjusted at the beginning.
I tried to upgrade its marlin firmware and I verify it, appeared and error.

Thanks in advance.
Top
bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Geetech I3 X Problem

Post by bang » Fri Jan 20, 2017 5:31 pm

Sounds like Z axis has a wrong moving direction?
Top
CGO
Posts: 3
Joined: Fri Jan 20, 2017 12:23 am

Re: Geetech I3 X Problem

Post by CGO » Sat Jan 21, 2017 5:18 am

At the beginning it goes up to 5mm then goes back, but it does not touch the hot bed as it was adjusted. However the printer starts working.
Top
bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Geetech I3 X Problem

Post by bang » Sat Jan 21, 2017 2:06 pm

The same problem as this post?
viewtopic.php?f=20&t=18420
Top
CGO
Posts: 3
Joined: Fri Jan 20, 2017 12:23 am

Re: Geetech I3 X Problem

Post by CGO » Mon Jan 23, 2017 4:00 am

I modified the recommended parameter but it did not work.
Top
Post Reply

Return to “Firmware”