I'm about to fit an E3D Lite6 to my M201 and therefore to the GTM32 board. Is it possible to set the thermistor type? The instructions on E3Ds page are for the various open firmware types out there: http://wiki.e3d-online.com/wiki/E3D-Lit ... Easy.21.29
I'd rather not replace the control board since I'd like to be able to swap back to the 2-into-1 heatblock when required.
Thank you.
M201 Set Thermistor Type
Re: M201 Set Thermistor Type
Hi,cerealkillers wrote:I'm about to fit an E3D Lite6 to my M201 and therefore to the GTM32 board. Is it possible to set the thermistor type? The instructions on E3Ds page are for the various open firmware types out there: http://wiki.e3d-online.com/wiki/E3D-Lit ... Easy.21.29
I'd rather not replace the control board since I'd like to be able to swap back to the 2-into-1 heatblock when required.
Thank you.
I'm afraid you can't make some modifications in firmware on GTM32 board...
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
The1Fl4sher
- Posts: 3
- Joined: Mon Mar 28, 2016 7:38 am
Re: M201 Set Thermistor Type
@ William Kwok : Are you sure you can not change the firmware.
Re: M201 Set Thermistor Type
Yes,cuz the GTM32 board is not open source...The1Fl4sher wrote:@ William Kwok : Are you sure you can not change the firmware.
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!