Printer would not connect after updating to 1.0.5 firmware

[Edvash]

Printer would not connect after updating to 1.0.5 firmware

the firmware was successfully updated, it works as a standalone, however , i can't connect it to the PC anymore
any suggestions?
Edan

[William]

Printer would not connect after updating to 1.0.5 firmware

the firmware was successfully updated, it works as a standalone, however , i can't connect it to the PC anymore
any suggestions?
Edan

Hi，Edvash
Has your devices manager detected this？If it has,you must choose the corresponding "COM" port in your slicer software.

1.png (76.25 KiB) Viewed 4106 times

If hasn't,you can try to change a USB port or a USB wire,that may work.
If all above have done and it doesn't work,i'm afraid you'd better return to the firmware you used before.