Prusa I3 Aluminum Sanguinololu

[ressma]

Hello, I have just assembled my Prusa I3 Aluminum printer with Sanguinololu controller. I downloaded what I believe to be the latest version of the firmware here http://www.geeetech.com/forum/viewtopic ... 20&t=17046. When the Arduino IDE compiles the code, it comes back with errors in the coding under the stepper file. The errors relate back to the defining of stepper speed variables. Should I be seeing these errors? Have I downloaded the latest firmware?

Any help is greatly appreciated. I will gladly send screenshots as soon as I am back on the machine that is connected to my printer. Thanks to all.

[Mark]

your firmware is this one, and try to use the arduino1.0.1 when uploading, the latest version always have some unknow problems.

QQ截图20160319140546.jpg (75.47 KiB) Viewed 3983 times