Prusa I3 not working.

Post Reply
yours31f
Posts: 2
Joined: Mon Oct 05, 2015 12:55 am

Prusa I3 not working.

Post by yours31f » Fri Oct 09, 2015 2:05 am

I have an issue with my prusa I3, iduino/ramps 1.4

It will not be recognized by any computer when the ramps is installed. This has been tested with 2 ramps, 2 iduinos, and 4 computers. I am out of ideas. The iduino is recognized with the ramps disconnected. Have rewired following instructions over and over.
Top
Post Reply

Return to “Firmware”