Burning bootloader for Sanguinololu

[bummer6]

After having tried and failed to flash the firmware for my Sanguinololu board, I'm running out of options and have decided it might help to re-burn the bootloader. I've tried the normal method in Arduino IDE 1.8.3 using an Arduino UNO as an ISP, but now when I try to flash the firmware I get "programmer not responding" errors. I'm guessing I need to burn the bootloader in some other way, so could someone tell me the proper way to get a new bootloader onto the Sanguinololu board so I can flash the firmware again?

[William]

You should uploading your firmware by Arduino IDE 1.0.1, refer to this link:
viewtopic.php?f=20&t=16433

[bummer6]

[quote=William post_id=81332 time=1509957166 user_id=51382]
You should uploading your firmware by Arduino IDE 1.0.1, refer to this link:
viewtopic.php?f=20&t=16433
[/quote]

I've tried following those instructions, but I still got sync errors. Now I need to know how to properly burn a bootloader onto the Sanguinololu so I can try again.

[Schillerft]

This is happening because of the error in the firmware of the software. You cannot resolve this problem by yourself so elitewritings.com review because this is the work of professional engineers and they can resolve this within minutes.