How to upload firmware for Dual Extruder i3 pro C

[shiva]

Hi
I recently brought Geeetech Dual Extruder Prusa i3 pro C kit. I assembled printer.
Still i dint get good print yet.
I am using Repetier-Host 1.5.3 Version.So please let me know,
1) Which firmware i have to download ?
2) How to upload firmware step by step guide?
3) Also please let me know best software setting for Dual Extruder i3 pro C .

Thanks
Shiva

[Sherry]

Hi
I recently brought Geeetech Dual Extruder Prusa i3 pro C kit. I assembled printer.
Still i dint get good print yet.
I am using Repetier-Host 1.5.3 Version.So please let me know,
1) Which firmware i have to download ?
2) How to upload firmware step by step guide?
3) Also please let me know best software setting for Dual Extruder i3 pro C .

Thanks
Shiva

hi,shiva,the related firmware and guidance have been sent to you email.the firmware is for i3 pro c of which main board is gt2560.please check.

[leoval]

HI, I have the same problem!!!

I need the last firmware for the Prusa i3 Pro C Dual Extruder and the instruction for update it.

Please send it to my mail leoval@gmail.com

Thanks a lot and have a nice day!!!

Leo

[Mark]

Hi Leo, download the firmware here:
http://www.geeetech.com/forum/viewtopic ... 10&t=17046

[Mooj]

Hello,

I have tried to upload the firmware update Marlin_GT2560-PI3_Pro_C.zip
but get and error

struct fops_t {

[Mooj]

Found solution, arduino 1.0.1. I was using a later version.