How to use the Firmware Toolkit to upgrade official website firmware

[William]

Hi,Guys

something about how to upgrade the hex firmware on the official website

Official website firmware address: https://www.geeetech.com/

UXQ2UX${BGDI9YYT~~HX~MW.png (302.29 KiB) Viewed 28422 times

1. Install the USB driver
First, turn on the power and connect the printer to the computer with a USB cable. Under normal circumstances, the computer will automatically search for and install the driver.
The latest motherboard GT2560 V4.0 communication chip is CH340

2.If the driver cannot be automatically installed on the computer when first connected, you need to recheck whether the driver has been successfully installed.

Right-click on your computer and select "My Computer"-> "Properties"-> "Device Manager".

com.png (108.18 KiB) Viewed 28424 times

If an exclamation point appears, you need to manually install the printer driver on your computer

!.png (135.59 KiB) Viewed 28424 times

you can refer to this:https://www.geeetech.com/forum/viewtopi ... RlcFtWdCG4

3. Download the Firmware toolkit and burn the firmware

Open tool firmware toolkit
Firmware toolkit download address:https://www.geeetech.com/download.html?download_id=40

xfw ff.png (77.7 KiB) Viewed 28424 times

4.Click select again to open the firmware you want to upgrade

ps:you need choose the com match your printer.

xhex.png (121.37 KiB) Viewed 28424 times

5. Click Upgrade from local and wait for the upgrade to complete.
The upgrade is completed as shown in the figure

f.png (517.1 KiB) Viewed 28424 times

6.Restart your printer and re-calibration your printer then enjoy it!