Geetech Duplicator 5 extruder inverted, how can i fix this problem

[neonshamanic]

I have the Duplicator 5 dual extruder mk8 but the extruder works in the wrong direction!

[Admin]

To help you better, we hope you can provide a video to illustrate your problem.

[neonshamanic]

the filament wheel is going at the wrong direction ... normali it should push into the extruder, but when i push it trought it comes back out.

[William]

Hi, You can check the direction of your extruder motor.
If it is reversed, it may be necessary to change its direction of operation.
You can provide specific videos so that we can solve the problem better.

[neonshamanic]

[img]c:\users\Jue\Documents\VID_20191008_160617.mp4[/img]

[neonshamanic]

[img]c:\users\Jue\Documents\VID_20191008_160617.mp4[/img]

how do i send a video please

[neonshamanic]

Hi, You can check the direction of your extruder motor.
If it is reversed, it may be necessary to change its direction of operation.
You can provide specific videos so that we can solve the problem better.

how do i send a video here please ?

[_kaktus_]

Hello.


To share the video, use an external service and share a link.

[neonshamanic]

Hello.


To share the video, use an external service and share a link.

https://youtu.be/ztN22HPXZbQ

[William]

Hi, for changes to the direction of operation of the motor,
you can refer to this: http://www.geeetech.com/forum/viewtopic ... 17&t=17037
I hope this can help you.