D200 Extruder Temp
Posted: Sat Sep 16, 2017 11:05 pm
Hello,
My D200 only goes to 230C is there a reason it is limited so low?
I use mostly all MakerGeeks filament and the MakerGeeks PLA temp is 235C, Raptor PLA is 245C, and PETG is 245C.
Is there a technical reason that it won't go over 230C? or was it just a mistake?
My D200 only goes to 230C is there a reason it is limited so low?
I use mostly all MakerGeeks filament and the MakerGeeks PLA temp is 235C, Raptor PLA is 245C, and PETG is 245C.
Is there a technical reason that it won't go over 230C? or was it just a mistake?