Prusa I3 Pro C - need new extruder holder
Posted: Thu Oct 13, 2016 8:26 pm
Hello Folks,
after more than a year of having the printer in storage, I finally have time to look at it again.
Sadly, my extruder has sagged a lot. I already bought a new aluminum holder from the GeeeTech store on Aliexpress, but can not find the part which attaches it to the two linear bearings. Where could I purchase this component?
Tam
after more than a year of having the printer in storage, I finally have time to look at it again.
Sadly, my extruder has sagged a lot. I already bought a new aluminum holder from the GeeeTech store on Aliexpress, but can not find the part which attaches it to the two linear bearings. Where could I purchase this component?
Tam