Geeetech

hi Sir
when I have given to print.
both repetier-host as pronterface. I have always received the same error:

RECV: Extruder switched off. MINTEMP triggered!
RECV: Error: Printer stopped due to errors. Fix the errors and use M999 to restart. (Temperature is reset. Set it after restarting)
[ERROR] Error: Printer stopped due to errors. Fix the errors and use M999 to restart. (Temperature is reset. Set it after restarting)

you know why it can happen???.

Thanks

Frankymad wrote:hi Sir
when I have given to print.
both repetier-host as pronterface. I have always received the same error:

RECV: Extruder switched off. MINTEMP triggered!
RECV: Error: Printer stopped due to errors. Fix the errors and use M999 to restart. (Temperature is reset. Set it after restarting)
[ERROR] Error: Printer stopped due to errors. Fix the errors and use M999 to restart. (Temperature is reset. Set it after restarting)

you know why it can happen???.

Thanks

Hi,
Check the the two thermistors,and you may find something useful in the following post:
http://www.geeetech.com/forum/viewtopic ... 23&t=17030

Ok i have make the test that show in the forum and i think that extruder termistor is wrong . What i do?
i have pruchase the printer a few days ago and i have not print anything.
Can you shipped me a repair part that is wrong?
thank you

Hi,
Did you get it from our official site or somewhere else?
I think you can contact the seller to have a replacement.
Regards