Page 1 of 1
Prusa Pro I3 C - Extruders still dont work
Posted: Thu Aug 27, 2015 4:14 am
by TAMHAN
Hello Folks,
after a long hiatus, I am back in action. I just installed the new firmware for my Prusa I3 Pro C, and the Extruders still cannot be turned.
My test sequence is:
a) Preheat ABS, wait until heat is reached
b) Move Axis -> Extruder -> turn pot, at which point nothing happens
Strangely, the printer operating software offers only one Extruder in the Move Axis option, while it offers two in the heatup menu and also welcomes me to a Prusa I3 C correctly.
Re: Prusa Pro I3 C - Extruders still dont work
Posted: Thu Aug 27, 2015 4:32 pm
by Mark
Where did you get the firmware? The old verdion has a problem that can cause this, try to burn the attached firmware here.
Re: Prusa Pro I3 C - Extruders still dont work
Posted: Mon Sep 07, 2015 5:53 am
by TAMHAN
Hello,
I took it from the sticky thread. Weirdly, the extruders can be turned from Repetier...this seems to be an issue of the LCD only!
Tam
Re: Prusa Pro I3 C - Extruders still dont work
Posted: Mon Sep 07, 2015 7:57 pm
by Mark
Do have some pictures about this?
"the extruders can be turned from Repetier" Can you control other parts of the printer by LCD, or just can not control the extruders?
Re: Prusa Pro I3 C - Extruders still dont work
Posted: Mon Sep 07, 2015 8:25 pm
by TAMHAN
Hello,
yes - the axis can be controled from both LCD and Repetier.
The Extruder can be commanded only from Repetier.
Re: Prusa Pro I3 C - Extruders still dont work
Posted: Tue Sep 08, 2015 11:01 pm
by Mark
Did you choose the option move 10mm? I remember this option does not work for extruder but only for X,Y and Z axis.
Re: Prusa Pro I3 C - Extruders still dont work
Posted: Wed Sep 09, 2015 2:34 am
by TAMHAN
Hello,
no, for me, neither of them worked.
Tam
Re: Prusa Pro I3 C - Extruders still dont work
Posted: Wed Sep 09, 2015 4:23 pm
by Mark
Can you show some pics about the LCD for me?
"the axis can be controled from both LCD and Repetier.The Extruder can be commanded only from Repetier.'
When I choose move 10mm, there is no extruer for me too.see the pic below: