can you send me the software for i pro c and how to install it my email is zx280f40@gmail.com
thanks for your support
![Very Happy :D](./images/smilies/icon_e_biggrin.gif)
yes I did all this but no use any idea how to check if the gt2500 board is dameg in extruder motor connection areazhangxueyou wrote:Is 0.58 got from A4988(the voltage between screw on A4988 and GND)?
How is it when you exchange extruder motor driver with x motor driver(A4988)?
You can control both extruder on Repetier-Host, referring to this page:
http://www.geeetech.com/forum/viewtopic ... 21&t=16512