dual extruder mount not looking so good

szeiger · Post by **szeiger** » Wed May 06, 2015 8:09 pm

My dual extruder mount is not looking so good. It is "sagging" a good 10 degrees.
Please advise

zhangxueyou · Post by **zhangxueyou** » Thu May 07, 2015 9:04 am

Are these 2 screws tight enough?

: QQ截图20150507090244.png (399.21 KiB) Viewed 8406 times

szeiger · Post by **szeiger** » Thu May 07, 2015 9:40 am

yes, in fact I have tightened them a couple of times.

zhangxueyou · Post by **zhangxueyou** » Thu May 07, 2015 10:40 am

Are the bottom screws tightened?

: QQ截图20150507103734.png (558.66 KiB) Viewed 8404 times

szeiger · Post by **szeiger** » Fri May 08, 2015 9:00 am

yes, but come on, you can clearly see where the sag is taking place, and it certainly isn't from those screws as then the extruders would be at an angle to the support, which they are not.
Something is up with the design for the support. If you have an improved version I can print it on my single extruder machine.

Please advise asap.

Thank you

zhangxueyou · Post by **zhangxueyou** » Fri May 08, 2015 9:58 am

You can try to print one yourself, see if it is still sagging.

dual extruder.zip: (128.37 KiB) Downloaded 501 times

Geeetech

dual extruder mount not looking so good

dual extruder mount not looking so good

Re: dual extruder mount not looking so good

Re: dual extruder mount not looking so good

Re: dual extruder mount not looking so good

Re: dual extruder mount not looking so good

Re: dual extruder mount not looking so good